5” SUBMERSIBLE MONOBLOCK MULTISTAGE PUMP
Internal capacitor and thermal protection and starting capacitor.
Version available without float.
The single-phase version is also available without the capacitor, this version is designed to work with a control panel supplied as an accessory.
Protection by the user in the three-phase version.
5” SUBMERSIBLE MONOBLOCK MULTISTAGE PUMP
A 5” multi-impeller single block submersible pump designed for pressurization, gardening and irrigation and lifting water in residential building service.
These pumps work immersed in wells and first collection tanks or cisterns.
The suction takes place through a filter located in the lower part of the pump.
The motor is located above the hydraulic part and is cooled by the pumped liquid.
Robust components allow the pump to run dry for short periods.
Impellers and diffusers are in technopolymer.
Double mechanical seal in carbon ceramic on motor side and silicon carbide / silicon carbide on pump side, with interposed oil chamber.
Operating range:
From 0.9 up to 7.2 m³/h with head up to 88 m.
Maximum immersion depth:
20 m.
Type of pumped liquid (clean free from solid or abrasive substances, non-viscous, non-aggressive, non-crystallized and chemically neutral, close to water characteristics)
Liquid temperature range:
From 0°C to +40°C
Maximum sand content:
50 g/m³
Maximum pump diameter:
138 mm.
Pump maximum length:
820 mm.
Motor protection class:
IP 68
Motor insulation class:
F
Power supply:
- Single-phase version: 230V 50 Hz
- Three-phase version: 230V/400V 50 Hz
Power cable:
15 m H07RN-F
Power cable types:
Fixed or removable, depending on versions
Special versions:
On request: different voltages and frequencies, different cable length
Certification:
CB
Trusted by Some of The
Best in The Industry
